Conector de iluminação Nanoleaf Flex — branco, cabo de 0,24 m, pack de 3

The Nanoleaf Flex lighting connector is a white, 0.24 m cable accessory designed to link modular LED Flex segments and expand Lines layouts. This pack of three connectors provides both electrical and physical connections between Flex modules, enabling continuous power and signal transfer while allowing flexible placement options. Each connector cable is engineered to bend up to 360 degrees, supporting curved or multi-dimensional arrangements and permitting installations around corners, along ceilings, and across complex surfaces.

Advantages

The connectors enable seamless extension of existing Nanoleaf Flex configurations without requiring additional power supplies or major rewiring. Their 0.24 m length provides reach for compact gaps while remaining discreet behind panels. The cables’ full 360-degree flex range allows for smooth transitions between segments and supports creative layout changes, and the white finish integrates with light-coloured installations for a minimal visual impact.

Suitable for

Key specifications

How to use

Power down the lighting system before disconnecting any modules. Attach each connector to the corresponding Flex segment connectors until they click securely, then route the 0.24 m cable to the adjacent panel and insert the mating connector. Ensure connectors are fully seated to maintain electrical contact and stable mechanical linkage. After installation, restore power and verify the lighting sequence and colour response across the extended segments. Use in place of standard Lines connectors where additional reach or bending capability is required.

Recommendations

For stable operation, avoid excessive tension on the cable and leave a small loop where the connector bends to preserve the 360° flex life. Keep connectors and cables away from direct heat sources and moisture. If planning a complex layout, map connector positions beforehand to ensure cable lengths and bend angles meet your design requirements.