Creality HI conjunto de ventoinha blower direita 24V 40x40x10mm para série Ender-3/CR-10 2102013616

Replace the right-side part cooling blower on your Creality 3D printer with this exact-fit fan assembly. It is used by makers and print farm operators who need consistent airflow to prevent warping and improve overhang quality on Ender-3, Ender-3 Pro, Ender-3 V2, CR-10, CR-10S, and CR-6 SE machines. The radial blower design delivers focused air directly to the nozzle area, while the 24V rating matches the printer's stock fan output.

Key specifications

• Fan type: DC radial blower (centrifugal)
• Dimensions: 40 x 40 x 10 mm
• Rated voltage: 24 V DC
• Rated current: 0.06 A – 0.1 A
• Connector: 2-pin JST-XH
• Cable length: 15 cm
• Bearing type: Sleeve
• Airflow: 2.5–3.5 CFM (4.2–5.9 m³/h)
• Noise level: 25–30 dBA
• Material: ABS plastic housing
• Operating temperature: -10°C to +70°C
• Lifespan: 30,000 hours

Why choose it

This blower fan is a direct replacement for the right-side cooling fan on popular Creality models. Its compact 40 mm footprint and standard screw mounting make installation straightforward, and the 2-pin connector plugs into the existing wiring without modification. The sleeve bearing provides quiet operation, and the ABS housing withstands the heat near the hotend.

Ideal use cases

• Restoring part cooling on a Creality Ender-3 or CR-10 after fan failure
• Upgrading to a fresh fan to reduce noise and improve print quality
• Keeping a spare for quick swap-outs in a busy print farm

Good to know

The fan is sold as a single assembly for the right side. It is compatible with 24V systems only; do not connect to 12V printers. The 15 cm cable is sufficient for routing along the existing harness. Verify your printer's connector orientation before installation.