Bocal de aspiração de pó Kärcher 2.863-234.0 para aspirador com depósito

The Kärcher 2.863-234.0 vacuum nozzle is an accessory for Kärcher Home & Garden multi-purpose (cylinder) vacuum cleaners WD 2–6 that captures drill dust directly at the drilling point. Its patented two-chamber system and foam rubber seal allow reliable suction of dust from walls, ceilings and common surfaces such as tiles, wallpaper, plaster, stone, concrete and wood. The nozzle adheres to the surface so overhead drilling can be performed without a second person; it supports drills with bit diameters up to 15 mm and connects easily to the vacuum hose for immediate use.

Advantages

The two-chamber design and foam rubber seal ensure efficient extraction of drill dust at the source, minimising residual dust and the need for sweeping or vacuuming afterwards. The accessory sticks reliably to common wall and ceiling surfaces and permits overhead drilling. It is simple to operate: connect the suction hose to the vacuum, switch on the cleaner, place the nozzle and drill. A yellow release switch lets you reposition the nozzle without turning off the vacuum cleaner. The nozzle is compatible with Kärcher multi-purpose vacuum cleaners WD 2–6 and fits drills with bit sizes up to 15 mm.

Suitable for

• Collecting drill dust when drilling into walls and ceilings
• Use on tiles, wallpaper, plaster, stone, concrete and wood
• Jobs where overhead drilling is required without an assistant
• Home renovation and light professional drilling tasks with drills up to 15 mm

Key specifications

• Manufacturer part number (MPN): 2.863-234.0
• Compatible with: Kärcher WD 2–6 multi-purpose (cylinder) vacuum cleaners
• Suitable drill diameter: up to 15 mm
• Colour: Black, Yellow
• EAN: 4054278207414

How to use

Connect the vacuum hose to the nozzle, switch on the Kärcher vacuum cleaner, position the nozzle over the intended drilling point so the foam rubber seal adheres to the surface, then start drilling while the vacuum extracts dust through the two-chamber system. For repositioning, press the yellow release switch to move the nozzle without turning off the vacuum. After drilling, switch off the vacuum and remove the nozzle following the vacuum manufacturer's instructions.

Recommendations

Use with Kärcher WD 2–6 cylinder vacuum cleaners for best compatibility. Confirm that the drill bit diameter does not exceed 15 mm. Ensure the contact surface is reasonably clean and flat so the foam rubber seal can adhere properly; avoid use on heavily uneven or crumbled surfaces.