Kit de ventoinhas para radiador 360mm ARGB PWM Jonsbo ZB-360 branco — 3 ventoinhas 120mm PWM ARGB para radiadores de refrigeração líquida

Jonsbo ZB-360 white is a 360mm ARGB PWM radiator fan kit composed of three 120mm PWM-controlled fans designed for mounting on liquid-cooling radiators or inside PC chassis. The fans provide variable-speed airflow via PWM control and synchronized addressable RGB illumination using standard ARGB headers. The white frame and blades offer a neutral appearance that integrates with light or dark builds while the set targets radiator cooling efficiency, low acoustic output at reduced speeds, and flexible lighting customization.

Advantages

The kit combines PWM speed control and ARGB lighting in a matched set of three 120mm fans, enabling coordinated fan curves and lighting effects when connected to compatible motherboards or controllers. The white fan frames help diffuse RGB lighting for consistent color reproduction. Designed for radiator use, the fans balance static pressure and airflow to improve heat transfer through fin arrays while maintaining relatively low noise at moderate RPMs.

Suitable for

• 360mm liquid-cooling radiators in PC gaming and workstation builds
• Case-mounted cooling where three 120mm fan positions are available
• Systems requiring synchronized ARGB lighting and PWM fan control
• Quiet operation scenarios with variable load and temperature-based fan curves

Key specifications

• Fan size: 3 × 120 mm
• Control type: PWM speed control
• Lighting: Addressable RGB (ARGB) compatible with standard 3-pin 5V ARGB headers
• Frame color: White
• Intended mounting: Radiator or chassis 120 mm positions for 360 mm configurations

How to use

Install the three fans onto a 360mm radiator or in corresponding case positions using the supplied screws, aligning airflow direction toward or away from the radiator according to your cooling configuration. Connect the PWM power cables to an available 4-pin PWM fan header on the motherboard or to a PWM fan hub to enable automatic speed control. Attach the ARGB cables to a compatible 3-pin 5V ARGB header or ARGB controller to manage lighting effects. After installation, configure fan curves and lighting in motherboard software or controller firmware to match thermal and aesthetic preferences.

Recommendations

For optimal radiator performance, set fan orientation to push or pull based on case airflow design, ensure cable routing avoids obstruction of fan blades, and use motherboard fan control or a dedicated hub to apply temperature-based PWM curves. Verify ARGB header voltage and connector pinout before connecting to avoid incompatibility. For quieter operation, configure a conservative fan curve that ramps up under load rather than running at maximum RPM continuously.