Lanview MO-C-S311213CL20 módulo transceptor de rede fibra ótica 1250 Mbit/s 1310 nm

MicroOptics MO-C-S311213CL20 is a compact fiber optic SFP transceiver module designed for 1250 Mbit/s data transmission over optical links. Operating at a 1310 nm wavelength and fitted with an LC connector, this SFP is suitable for single-mode and some multimode fiber applications depending on link design and equipment compatibility. The module supports hot-swappable insertion into SFP ports on switches, routers and other network devices that accept standard SFP form factor transceivers.

Advantages

The transceiver provides a standardized SFP form factor with a clear physical interface (LC) and a single-wavelength optical interface at 1310 nm. It offers a 1250 Mbit/s data rate that matches Gigabit Ethernet and some Fibre Channel deployments, while supporting hot-swappable operation for easy field replacement without powering down equipment. The module is compliant with Multi-Source Agreement (MSA) form-factor expectations and is tested for interoperability with common SFP ports.

Suitable for

• Gigabit Ethernet uplinks between network switches and routers
• Short to medium-range single-mode fiber connections using 1310 nm wavelength
• Fibre Channel links or legacy systems requiring 1250 Mbit/s optical transceivers
• Field replacements and upgrades where hot-swappable SFP modules are required

Key specifications

• Data rate: 1250 Mbit/s
• Optical wavelength: 1310 nm
• Connector type: LC duplex
• Form factor: Small Form-factor Pluggable (SFP)
• Fiber type: Designed for single-mode fiber; check multimode compatibility per link
• Hot-swappable: yes

How to use

Install the MicroOptics MO-C-S311213CL20 by inserting it into a compatible SFP port on the powered network device until it clicks into place; no tools are required. Connect an LC-terminated fiber patch cable to the module’s connector, observing transmit/receive orientation. After insertion and link-up, verify link status and configuration on the host device; configure speed and duplex settings if the device requires manual settings. To remove, release any latch or ejector on the host port and pull the module straight out while avoiding stress on the fiber.

Recommendations

Confirm compatibility with your network equipment and fiber type prior to purchase. Use appropriate ESD protection when handling the transceiver and keep dust caps on the optical port when not connected. For reliable operation, ensure connectors are clean and use certified patch cables; verify link budget and maximum reach for single-mode or multimode deployments at 1310 nm.