Mala rígida B&W Cases 5000/B/SI

The B&W Cases 5000/B/SI is a hard case designed to protect cameras and photographic equipment from impacts, moisture and dust. With a black exterior and a lightweight yet rigid construction, this case combines portability with solid protection. The interior is customizable to accommodate different camera bodies, lenses and accessories, allowing users to configure the storage layout according to their gear.

Advantages

The case offers a rugged outer shell that resists shocks and environmental exposure while remaining relatively light for transport. Its customizable foam insert enables secure positioning of delicate items and reduces movement during transit. The design includes reliable latches and a handle sized for comfortable carrying; materials used are intended to provide long service life and low maintenance.

Suitable for

• Protecting mirrorless and DSLR cameras during travel
• Transporting lenses, flashes and small accessories
• Storage of equipment in vehicles or studio environments
• Field shoots where impact and moisture protection are required

Key specifications

• Hard, impact-resistant outer shell in black finish
• Lightweight construction combined with rigid stability
• Customizable internal foam for tailored equipment fit
• Secure latch system and ergonomically shaped carry handle
• Protection against dust and splashes suitable for outdoor use

How to use

Open the latches and remove or adjust the foam insert to match the shape of your camera and accessories. Place each item into its allocated compartment so that it sits snugly without excessive pressure. Close the lid and fasten the latches until they click to ensure a tight seal. Use the handle to carry the case or stow it in a vehicle or storage area for safe keeping.

Recommendations

For optimal protection, arrange heavier items at the bottom and ensure lenses and delicate parts are fully cushioned by the foam. Inspect latches and seals periodically, and avoid prolonged immersion in water. Clean the exterior with a damp cloth and allow the interior foam to dry completely if it becomes wet.