Módulo de ventoinha para caixa de computador Montech GF120 V2 ARGB 12 cm branco 1 unid.

The Montech GF120 V2 ARGB is a 120 mm computer case fan module in white, designed to provide balanced airflow and quiet operation for PC chassis cooling. It features a Hydro Dynamic Bearing (HDB) for extended lifespan and stable performance across its rotational speed range. The fan operates at 12 V and delivers variable airflow suitable for general case ventilation and component cooling while integrating addressable RGB lighting for visual customization.

Advantages

The HDB bearing reduces friction and noise while increasing durability compared with sleeve bearings. With a rotational speed range from 800 to 1600 RPM and a maximum air pressure of 1.71 mmH2O, the GF120 V2 ARGB offers a compromise between airflow and static pressure, making it effective in typical case setups and on moderate cooling obstacles such as dust filters and drive cages. The white finish provides a neutral aesthetic that integrates well with light-themed builds. ARGB lighting adds customizable illumination while PWM control enables quieter operation at low loads.

Suitable for

• General PC case ventilation to improve overall thermal management
• Front or rear intake/exhaust installation in mid-tower and full-tower cases
• Cooling air-streaming across radiators in low to medium restriction setups
• Builds requiring coordinated ARGB lighting and a white visual theme

Key specifications

• Fan diameter: 120 mm
• Frame thickness: 25 mm
• Rotational speed: 800–1600 RPM
• Maximum air pressure: 1.71 mmH2O
• Bearing type: Hydro Dynamic Bearing (HDB)
• Operating voltage: 12 V
• Weight: 0.186 kg
• Color: White

How to use

Install the fan in the desired fan slot inside the PC case, orienting airflow according to the case layout (usually intake at the front/bottom or exhaust at the rear/top). Secure the fan with screws through the mounting holes and connect the power and control cables to the motherboard or fan controller: use the 3- or 4-pin connector for PWM speed control and the ARGB header for addressable lighting control, following the motherboard or controller manual for correct pin alignment. Ensure cables are routed to avoid obstructing airflow or interfering with moving parts.

Recommendations

For balanced noise and cooling, use PWM control to keep idle speeds lower and allow higher RPM under load. When mounting on radiators, place the fans to achieve a consistent push or pull configuration and check clearance in the case. Regularly clean dust filters and fan blades to maintain airflow performance. Match ARGB control software or a compatible controller to synchronize lighting with the rest of the system.