Módulo sem fios Philips CRD22/00 — Wi‑Fi 5 (802.11ac), Wi‑Fi 6 (802.11ax) e Bluetooth substituição

Philips CRD22/00 is a replacement wireless communication module designed to restore or upgrade network and Bluetooth connectivity in compatible Philips devices. The module supports Wi‑Fi 5 (802.11ac), Wi‑Fi 6 (802.11ax) and Bluetooth, enabling improved wireless performance for streaming, remote control and data transfer. As a spare part, it is intended for service and repair tasks where original wireless functionality needs to be recovered or enhanced.

Advantages

The module provides backward-compatible support for Wi‑Fi 5 while adding Wi‑Fi 6 capabilities for higher throughput and better spectral efficiency. Integrated Bluetooth support allows device pairing and local data exchange. As a direct replacement part for compatible Philips hardware, it simplifies repairs and can help extend device lifetime without full unit replacement. The design follows original-equipment interfaces to maintain compatibility with existing device housings and connectors.

Suitable for

• Repairing a Philips device that has lost wireless or Bluetooth connectivity
• Upgrading an older Philips product to support Wi‑Fi 6 performance improvements
• Restoring streaming and remote-control features dependent on wireless networking
• Service centers performing board-level replacements or refurbishments

Key specifications

• Wireless standards supported: Wi‑Fi 6 (802.11ax) and Wi‑Fi 5 (802.11ac)
• Bluetooth: integrated short-range wireless technology for device pairing and data transfer
• Function: replacement communication module for compatible Philips devices
• Use case: supports streaming, remote control, firmware updates and local data exchange
• Form factor: module intended for board-level installation in compatible devices

How to use

Install the module by following the service instructions for the specific Philips device model: power off the device, open the enclosure according to manufacturer guidance, remove the defective wireless module and replace it with the Philips CRD22/00 replacement. Reassemble the device, power it on and verify wireless and Bluetooth functionality through the device settings or diagnostics. If required, apply any system firmware updates or driver configuration recommended by Philips to ensure full compatibility.

Recommendations

Use original Philips service documentation when performing the replacement to ensure correct handling of board-level components. Verify device model compatibility before purchase and avoid forcing connectors; if unsure, seek assistance from an authorized service center. After installation, check for available firmware updates to take full advantage of Wi‑Fi 6 capabilities and security patches.