módulo transceptor de cobre BlueOptics GLC-10G-T-BO 10000 Mbit/s RJ-45

The BlueOptics GLC-10G-T-BO is a copper SFP+ transceiver module with an RJ-45 interface designed for 10GBASE-T Ethernet connections. It supports data rates up to 10000 Mbit/s and fits SFP+ ports that accept 10GBASE-T copper modules. The module is compact and lightweight (approximately 20 g), enabling straightforward installation in compatible switches, routers and other networking equipment that support SFP+ copper transceivers.

Advantages

The module follows MSA-compliant SFP+ mechanical and electrical standards to ensure interoperability with a wide range of hardware platforms. It supports 10G speeds over twisted-pair copper cabling for short-distance links, and implements digital diagnostics features where supported by the host device to provide real-time parameters such as supply voltage, temperature and optical/electrical status. The BlueOptics component selection and manufacturing process aim to provide stable operation and extended service life for demanding network environments.

Suitable for

• High-speed server-to-switch or switch-to-switch connections within data centers up to short copper distances
• Upgrading network ports to 10GBASE-T without replacing existing RJ-45 cabling
• Network equipment that requires MSA-compliant SFP+ copper transceivers with RJ-45 interface

Key specifications

• Interface type: RJ-45 copper SFP+ module
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Form factor: SFP+ (10GBASE-T compatible)
• Typical use distance: short-range over Cat6/Cat6a twisted-pair cabling (industry typical up to tens of meters depending on cable and hardware)
• Weight: approximately 0.02 kg
• Compliances: Designed to meet common industry standards for SFP+ modules and regulatory requirements (e.g., CE/RoHS where applicable)

How to use

Insert the BlueOptics GLC-10G-T-BO module into an available SFP+ slot on a compatible switch, router or network appliance while the host device is powered down or following the host vendor's hot-swap instructions. Connect the RJ-45 port on the module to existing Cat6/Cat6a copper cabling. Verify link status and speed on the host device management interface and enable any required settings for 10GBASE-T operation. If the host supports digital diagnostics, access the diagnostic registers to monitor operational parameters.

Recommendations

Use high-quality Cat6a or better cabling and shielded connectors for optimal 10GBASE-T performance. Confirm host device compatibility with third-party SFP+ copper modules in vendor documentation or by testing, and keep device firmware up to date to ensure proper recognition and diagnostic functionality.