Módulo transceptor de fibra ótica BlueOptics AT-SP10ER40A/I-BO SFP+ 40000 m

The BlueOptics AT-SP10ER40A/I-BO SFP+ 40000 m is a fiber optic transceiver module designed for long-distance high-speed links. It uses an SFP+ interface and LC duplex connectivity to transmit and receive optical signals over single-mode fiber at 1550 nm wavelength. The module has an aluminium housing and a lightweight design (approximately 20 g) suitable for integration into switches, routers and storage hardware that support SFP+ optics. It is intended for Ethernet and other optical transmission protocols requiring reliable 10 Gbit/s performance across extended ranges up to 40 km.

Advantages

This BlueOptics SFP+ module follows MSA-compatible form factor and LC duplex connector standards, enabling broad interoperability with equipment that supports 10GBASE-ER optics. The aluminium enclosure provides mechanical protection and thermal stability while the compact SFP+ format supports dense port deployments. The transceiver is built to support typical monitoring functions and is compatible with equipment designed for similar 10G ER modules, providing a balance of long reach and operational reliability for optical links.

Suitable for

Key specifications

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on the network device until it latches, then connect an LC duplex single-mode patch cable between transceivers or to a patch panel. Ensure both ends use single-mode fiber and correct polarity for transmit and receive. Configure the host device for 10G operation as required by the platform and verify link status through the device management interface. If digital diagnostic monitoring is available and supported by the host, enable or check DDM/DOM to monitor parameters such as optical power and temperature.

Recommendations

Use single-mode fiber with appropriate attenuation budgets for long-reach links and verify transceiver compatibility with the network hardware vendor. Avoid exposing the transceiver to contaminants on the fiber connectors; keep dust caps on unused ports and clean connectors before mating. Confirm that the host device supports the module’s monitoring features if remote diagnostics are required.