Módulo transceptor de fibra ótica BlueOptics BNDR-BO SFP+ LC alumínio 20g

The BlueOptics BNDR-BO SFP+ LC Aluminium 20g is a fiber optic transceiver module designed for 10 Gigabit data links over multimode fiber. Constructed with an aluminium housing and an LC duplex connector, this SFP+ module supports short-range optical transmission using 850 nm wavelength components suitable for standard 10GBASE-SR applications. The module is compact and lightweight (approximately 20 g) and follows common SFP+ form-factor interoperability guidelines.

Advantages

The compact aluminium housing provides mechanical protection and helps dissipate heat during continuous operation. An LC duplex interface enables simultaneous transmit and receive channels over multimode fiber for duplex 10 Gbps links. The module is supplied in the SFP+ interface type, which is compatible with a wide range of networking equipment that accepts standard SFP+ transceivers. Its lightweight construction simplifies handling and installation in rack-mounted or modular systems.

Suitable for

Key specifications

How to use

Install the transceiver into an SFP+ slot on a compatible switch, router or host adapter while the equipment is powered down or following the vendor’s hot-swap guidance. Connect LC duplex multimode fiber patch cords to the module’s LC ports, taking care to maintain correct transmit-to-receive orientation. Verify link status through the host device’s interface and, if available, monitor diagnostic information via the device management system. Follow standard electrostatic discharge (ESD) precautions when handling the module and keep protective dust caps on unused ports.

Recommendations

Use multimode fiber patch cords and structured cabling components rated for 10 Gbps and ensure connectors are clean to maintain optimal optical performance. Confirm that the target equipment supports SFP+ SR transceivers and any digital diagnostic monitoring features before deployment. For best results, route fiber to minimize bends tighter than manufacturer bend-radius recommendations and perform link validation after installation.