Módulo transceptor de rede BlueOptics SFP28-25G-ER-LE-BO fibra ótica 25000 Mbit/s 1310 nm

The BlueOptics SFP28-25G-ER-LE-BO network transceiver module is a compact fiber optic SFP28 form-factor device engineered for 25 Gbit/s links. It uses a 1310 nm wavelength designed for extended reach connections, offering a lightweight solution for high-speed fiber networks. With a small physical footprint and a module weight of about 20 g, the transceiver is compatible with SFP28 ports used in modern switches, routers and optical equipment in data centers and enterprise environments.

Advantages

This SFP28 module supports a maximum data transfer rate of 25000 Mbit/s and is optimized for long-distance transmission at 1310 nm. Its SFP28 interface ensures hot-pluggable installation and broad compatibility with equipment that accepts SFP28 transceivers. The lightweight construction simplifies handling and installation while preserving mechanical reliability and signal integrity expected for 25 G Ethernet links.

Suitable for

• 25 Gbit/s uplinks between switches and routers in data centers
• Long-reach optical connections where 1310 nm wavelength is required
• Enterprise network aggregation and backbone segments

Key specifications

• Interface type: SFP28 hot-pluggable transceiver
• Maximum data transfer rate: 25000 Mbit/s (25 Gbit/s)
• Operating wavelength: 1310 nm for extended reach
• Form factor: SFP28 compliant module
• Module weight: approximately 0.02 kg

How to use

Install the transceiver into an available SFP28 port on compatible networking equipment following the device manufacturer's instructions. Ensure fiber patch cords and connectors match the required type and polarity for 1310 nm single-mode links. After insertion, verify that the host device recognizes the module and that link status LEDs indicate an active connection. Configure network interfaces and link settings on connected equipment as needed to enable 25 Gbit/s operation.

Recommendations

Store and handle the module in a clean, static-free environment. Use single-mode fiber and quality connectors appropriate for 1310 nm long-reach links, and verify optical power budgets and loss budgets for the intended installation distance before deployment.