Módulo transceptor SFP BlueOptics 100-01660-BO 1250 Mbit/s fibra ótica

The BlueOptics 100-01660-BO SFP transceiver module is designed for fiber optic network connections with a maximum data transfer rate of 1250 Mbit/s. Housed in a compact SFP metal case with a silver finish, this module offers a small form factor suitable for standard SFP ports. It is manufactured to industry conformity and meets CE, FCC and RoHS directives, and its high mean time between failures (MTBF) of 1,000,000 hours indicates long operational reliability. The module's lightweight construction (approximately 20 g) simplifies handling and installation in networking hardware.

Advantages

The module supports a 1250 Mbit/s fiber link in a standard SFP form factor, allowing interoperability with equipment that accepts SFP transceivers. Compliance with CE, FCC and RoHS standards ensures regulatory conformity for many installations. Its compact metal housing in silver provides durability and helps with heat dissipation, while the high MTBF signals predictable long-term operation. The low weight and standard interface type make it straightforward to install and replace in compatible switches and routers.

Suitable for

• Upgrading or expanding fiber optic ports on compatible switches and routers
• Point-to-point fiber links requiring up to 1250 Mbit/s
• Data center uplinks and edge network segments with SFP slots
• Environments where regulatory compliance (CE/FCC/RoHS) is required

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Housing: compact metal SFP module, silver colour
• MTBF: 1,000,000 hours
• Weight: approximately 0.02 kg
• Standards compliance: CE, FCC, RoHS

How to use

Ensure the host device supports SFP transceivers and is powered down or prepared according to the device manufacturer's hot-plugging instructions. Align the transceiver with the SFP port and insert it until it locks into place. Connect the appropriate fiber optic cable to the transceiver connector, observing correct fiber type and connector polarity. After installation, verify link status and configure the network device as required for the new fiber interface. Follow any specific device prompts or network management procedures to activate the port.

Recommendations

Use consistent fiber types and connector standards on both ends of the link, keep fiber connectors clean, and follow electrostatic discharge precautions during handling. Verify compatibility with the host device and consult the device's documentation for supported transceiver specifications and recommended installation practices.