Módulo transceptor SFP+ BlueOptics 10G-SFPP-SR-S-BO 10000 Mbit/s 850 nm

The BlueOptics 10G-SFPP-SR-S-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s short-range connections. It uses an 850 nm wavelength for multimode fiber links, features an LC duplex connector and complies with RoHS. The module is lightweight (approximately 20 g) and follows MSA physical and electrical standards to ensure interoperability with compatible switches, routers and storage devices that support SFP+ SR optics.

Advantages

This SFP+ transceiver provides up to 10 000 Mbit/s throughput over multimode fiber for distances typical of short-reach applications, while preserving interoperability through MSA-compliant form factor and LC duplex interface. The module supports digital diagnostic monitoring (DDM/DOM) where supported by host hardware, enabling real-time readout of parameters such as supply voltage, temperature, transmit power and receive power to aid remote troubleshooting. The lightweight silver module is RoHS compliant and is manufactured to industry quality practices for stable long-term operation.

Suitable for

• 10 Gbit/s Ethernet links in data centers and aggregation layers
• Short-reach connections over multimode fiber (server to switch, switch-to-switch)
• High-speed storage networking and Fibre Channel over Ethernet applications
• Environments where DDM/DOM monitoring is required for link diagnostics

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Optical wavelength: 850 nm (multimode fiber)
• Connector: LC duplex
• Typical reach: short-range multimode links (SR)
• Compliance: RoHS, MSA mechanical/electrical compatibility
• Weight: approx. 0.02 kg
• Module colour: silver

How to use

Install the transceiver into an empty SFP+ port of a compatible switch, router or host adapter until it locks into place; connect an LC duplex multimode fiber patch cable (observe TX/RX orientation). Ensure the host device supports 10GBASE-SR optics and, if required, enable or verify DDM/DOM support in the device firmware or management interface to access diagnostic values. Power down is generally not required for hot-pluggable SFP+ modules, but follow your hardware vendor's guidance for safe insertion and removal.

Recommendations

For optimal link quality use high-quality OM3/OM4 multimode fiber and matched LC duplex patch cords, keep connectors clean, and verify transceiver compatibility with the specific hardware model. Use DDM/DOM readings to monitor optical power and temperature and schedule maintenance if abnormal values are observed.