Módulo transceptor SFP BlueOptics 1442610G1C-BO fibra ótica 10000 m

The BlueOptics 1442610G1C-BO SFP transceiver module is a fiber optic 10000 m module designed for high-speed single-mode applications. Housed in aluminium and weighing approximately 20 g, this SFP offers a compact form factor compatible with standard SFP slots and LC duplex fiber connectors. It supports 1000BASE-LX optical transmission over single-mode fiber at 1310 nm, providing reliable data links for network equipment that accepts SFP 1000BASE-LX modules.

Advantages

The module’s aluminium casing delivers mechanical durability while maintaining a low weight suitable for dense installations. Built to MSA SFP form-factor standards, it supports industry-standard interfaces and LC duplex connection to enable send and receive channels over separate fibers. The design is intended for long-distance single-mode transmission up to 10 km and includes digital diagnostics monitoring functionality when supported by host hardware for real-time parameters such as optical power and temperature.

Suitable for

• Fiber uplinks between switches and routers over single-mode fiber
• Long-distance links in campus or metropolitan area networks up to 10 km
• Interconnects for storage and server systems supporting SFP 1000BASE-LX
• Replacement or spare transceivers in compatible networking platforms

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Optical standard: 1000BASE-LX, single-mode fiber
• Wavelength: 1310 nm (transmit and receive)
• Maximum transmission distance: up to 10,000 m (10 km) over single-mode fiber
• Connector: LC duplex
• Housing material and colour: aluminium
• Weight: approximately 0.02 kg
• Digital diagnostics monitoring (DDM) supported when host hardware enables the feature

How to use

Install the SFP transceiver into a compatible SFP slot on the network device following the device manufacturer’s hot‑swap or insertion guidelines. Connect an LC duplex single-mode fiber patch cable with correct polarity to the module’s LC connector. Configure the host device network interface as required for 1000BASE-LX operation and verify link status. If digital diagnostics monitoring is available and supported by the host, use the management interface to read real‑time optical and electrical parameters for link validation and troubleshooting.

Recommendations

Use high-quality single-mode fiber and LC duplex patch cords to achieve the specified 10 km range; avoid bending the fiber beyond recommended bend radii and ensure connectors are clean before mating. Confirm host device compatibility with SFP 1000BASE-LX modules and enable DDM/DOM support in the device firmware to access diagnostic data where applicable.