Módulo transceptor SFP BlueOptics 3HE01454CA-BO 155 Mbit/s fibra ótica

The BlueOptics 3HE01454CA-BO 155 Mbit/s Fiber optic SFP transceiver module is a compact, hot-pluggable optical interface designed for short- and medium-range data transmission in networking equipment that supports the SFP form factor. Supporting a maximum data transfer rate of 155 Mbit/s and housed in a silver metal enclosure, this transceiver provides a standardized connection between fiber-optic cable and switch, router or other compatible communications hardware. With a mean time between failures (MTBF) of 1,000,000 hours, it is intended for continuous operation where predictable uptime is important.

Advantages

The SFP transceiver offers a compact SFP form factor for easy hot-swap installation and broad compatibility with devices that accept SFP modules. Its fiber-optic interface enables low-loss, high-integrity signal transmission over optical fiber at up to 155 Mbit/s. The metal housing in silver provides mechanical protection and supports thermal performance for stable operation. An MTBF rating of 1,000,000 hours indicates a design focused on reliability for network links.

Suitable for

• Connecting fiber-optic links between switches and routers supporting SFP modules
• Upgrading or replacing optical interfaces in telecommunications and networking equipment
• Implementing point-to-point fiber segments in enterprise or campus networks
• Installations requiring a compact, hot-pluggable optical transceiver at 155 Mbit/s

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 155 Mbit/s
• Interface type: Fiber optic (SFP)
• Product colour: Silver metal housing
• Reliability: Mean time between failures (MTBF) 1,000,000 hours

How to use

Ensure the host device supports SFP modules and compatible data rates before installation. With the host power on or off depending on vendor guidelines, insert the BlueOptics SFP module into an available SFP slot until it seats securely and the module latch engages. Connect the appropriate fiber-optic cable to the module’s optical port, observing correct connector type and polarity. Configure the host device network settings and verify link status through the device management interface or status LEDs. To remove the module, follow the host vendor’s hot-swap procedure and carefully disconnect the fiber cable before extracting the transceiver.

Recommendations

Use certified fiber-optic cable and compatible connectors, observe ESD precautions when handling the module, and consult the host equipment documentation for supported SFP types and installation procedures to ensure reliable link operation at 155 Mbit/s.