Módulo transceptor SFP+ BlueOptics 99Y0226-BO 10000 Mbit/s fibra ótica

The BlueOptics 99Y0226-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s network links. Its compact SFP+ form factor and silver housing allow integration into compatible switches, routers and optical equipment where a small, hot-pluggable 10 Gigabit interface is required. The module is specified with a maximum data transfer rate of 10000 Mbit/s and a calculated MTBF of 1,000,000 hours, and it meets CE, FCC and RoHS regulatory standards.

Advantages

This transceiver provides a standardized SFP+ interface for high-speed fiber connections, enabling reliable 10 Gbit/s data transmission in a compact module. Its small size and hot-swappable design simplify installation and replacement without powering down equipment. Compliance with CE, FCC and RoHS ensures conformity with common regulatory and safety requirements in networking environments.

Suitable for

• 10 Gigabit uplinks between switches and routers
• Fiber connections in data center aggregation and access layers
• High-bandwidth links for storage networking or virtualization hosts
• Replacing or upgrading existing SFP+ fiber ports

Key specifications

• Form factor: SFP+
• Maximum data transfer rate: 10000 Mbit/s
• Interface type: SFP+
• Product colour: Silver
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours
• Regulatory compliance: CE, FCC, RoHS

How to use

Ensure the host device supports SFP+ transceivers and is powered off or follows the manufacturer's hot-swap procedure. Align the module with the SFP+ cage and insert until it latches; when installed while the system is powered, verify that the device recognizes the module and that link/activity LEDs indicate a proper optical connection. Connect suitable fiber patch cables to the transceiver's optical ports, observing correct connector types and fiber polarity. For removal, release the latch mechanism and pull the module straight out, protecting optical interfaces with dust caps when not in use.

Recommendations

Use single-mode or multimode fiber and connectors that match your network design and the transceiver's optical characteristics. Keep optical connectors clean to avoid signal degradation, and follow electrostatic discharge (ESD) precautions when handling the module. Verify compatibility with your switch or router firmware and vendor interoperability lists before deployment.