Módulo transceptor SFP BlueOptics EX-SFP-1FE-FX-ET-BO fibra ótica 2000 m

The BlueOptics EX-SFP-1FE-FX-ET-BO is an SFP fiber optic transceiver module designed for 100BASE-FX optical links with a reach up to 2000 m over multimode fiber. The compact module has an aluminium housing and weighs approximately 20 g, and it uses a standard LC duplex connector and SFP interface to integrate with compatible switches, routers and other networking equipment that support SFP transceivers.

Advantages

The module supports 100BASE-FX optical signalling with 1310 nm transmit and receive wavelengths and follows MSA-compliant SFP form factor and LC duplex connectivity for straightforward interoperability. Its lightweight aluminium construction contributes to easy installation and stable mechanical fit in SFP ports. BlueOptics units are tested for compatibility with major hardware platforms that accept equivalent 100BASE-FX SFP transceivers, enabling replacement or expansion without requiring vendor-specific parts.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP transceiver into a compatible SFP slot on your switch, router or media converter, ensuring the module is fully seated and latched according to the host device instructions. Connect LC duplex fiber patch cords to the transceiver, observing correct Tx/Rx orientation. Confirm link settings on the host device and verify that the port recognises the 100BASE-FX link. If your hardware supports digital diagnostics (DDM/DOM), enable and monitor the available parameters in the device management interface to track optical performance.

Recommendations

Use high-quality LC duplex multimode patch cords and properly terminated patch panels to achieve optimal link performance. Verify that the host device supports 100BASE-FX SFP modules and, if required, enable digital diagnostics support in the system firmware to monitor supply voltage, laser bias, optical power and temperature. Avoid bending or stressing fiber cables near connectors and ensure clean connector endfaces before connecting.