Módulo transceptor SFP BlueOptics IE-SFP-1FESLC-T-BO 1250 Mbit/s 1310 nm

The BlueOptics IE-SFP-1FESLC-T-BO is a compact fiber optic SFP transceiver module designed for Gigabit-class optical links. It supports a maximum data transfer rate of 1250 Mbit/s at a wavelength of 1310 nm, features a metal housing in silver, and operates from a 3.3 V input supply. With a lightweight design of approximately 20 g and SFP form factor compatibility, this module is intended for use in networking hardware that accepts SFP optics for single-mode fiber connections and extended reach.

Advantages

The module provides a standardized SFP form factor and a metal casing that aids mechanical stability and heat dissipation. Its optical operation at 1310 nm allows for extended single-mode fiber reach up to 40 km under appropriate link conditions. The modest power requirement (3.3 V) and small footprint simplify integration into switches, routers and media converters that support SFP optics. The silver finish makes it visually consistent with typical network optics inventory.

Suitable for

Key specifications

How to use

Install the SFP transceiver into an SFP port of a compatible switch, router or media converter until it latches into place. Connect single-mode fiber using the appropriate LC or connector type required by your cabling and ensure the transmit and receive fibers are correctly oriented between link endpoints. Verify that the host device recognizes the module and configure the interface for 1.25 Gbit/s operation where applicable. Observe standard ESD precautions during handling and avoid touching the optical interfaces; keep protective dust caps on connectors when not in use.

Recommendations

For reliable long-distance links, use low-loss single-mode fiber and matching patch cords, check the link budget and attenuation per kilometer, and perform optical power measurements after installation. Ensure the host hardware supports SFP modules and the required data rate at 1310 nm before deployment.