Módulo transceptor SFP+ BlueOptics ISFP-10G-SR-BO LC alumínio 10G

The BlueOptics ISFP-10G-SR-BO LC Aluminium 10G is a 10G SFP+ transceiver module designed for short-range multimode fiber links. It uses an LC duplex connector and follows MSA-compliant SFP+ form factor and signaling. The aluminium housing provides a lightweight and durable enclosure, with a module weight of approximately 20 g. The transceiver supports 10G data rates over multimode fiber and is intended for integration into compatible network equipment that accepts SFP+ modules.

Advantages

The module supports 10GBASE-SR optical transmission over multimode fiber with 850 nm wavelength for both transmitter and receiver, enabling simultaneous send and receive on a duplex LC connection. Constructed to MSA specifications, the transceiver is built for interoperability with major networking platforms that accept SFP+ optics. Its compact SFP+ form factor and aluminium housing offer a balance of mechanical robustness and low weight suitable for dense installations. The product is engineered to provide dependable short-reach connectivity while maintaining compatibility with standard 10G Ethernet and fibre channel over Ethernet use cases.

Suitable for

Key specifications

How to use

Install the BlueOptics ISFP-10G-SR-BO into an SFP+ slot on compatible network equipment while the device is powered down or following the manufacturer’s hot-plug guidance. Connect an LC duplex multimode fiber patch cable between this transceiver and the corresponding module or patch panel, ensuring correct Tx/Rx alignment. Verify link status and negotiate speed on the host device; the module operates at 10 Gbps over appropriate multimode fiber and distance. If the host supports Digital Diagnostics Monitoring (DDM/DOM), enable or query the diagnostic interface according to the equipment documentation to monitor optical parameters.

Recommendations

Use OM3/OM4 multimode fiber for best short-range 10G performance and maintain clean LC connectors to minimise insertion loss. Confirm the target network hardware accepts MSA-compliant third-party SFP+ modules and supports DDM/DOM if diagnostics are required. Observe ESD precautions when handling the module and store it in protective packaging when not in use.