Módulo Transceptor SFP BlueOptics SBC-SFPSM-10G-BO 10000 Mbit/s

The BlueOptics SBC-SFPSM-10G-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s links. Housed in a metal case and weighing 20 g, it supports single-mode fiber connections and offers a high mean time between failures (MTBF) of 1,000,000 hours. The module follows MSA SFP+ mechanical and electrical standards and is intended for use in compatible switches, routers and other network hardware that accept SFP+ 10G modules.

Advantages

The module provides 10,000 Mbit/s data transfer over single-mode fiber with an LC duplex connector and supports simultaneous transmit and receive channels. Its metal housing improves mechanical durability and thermal dissipation. A long MTBF and use of industry-grade components contribute to stable long-term operation. The SFP+ form factor ensures compact, hot-pluggable installation in appropriately equipped network devices.

Suitable for

• 10 Gbit/s Ethernet uplinks between switches and routers
• High-speed server and storage interconnects
• Long-reach single-mode fiber links within campus and data center networks (up to typical LR distances)
• Replacement or spare SFP+ modules in compatible network hardware

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10,000 Mbit/s (10 Gbit/s)
• Connector type: LC duplex (single-mode fiber)
• Housing: metal for improved durability and heat dissipation
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Install the BlueOptics SBC-SFPSM-10G-BO into an SFP+ slot of a compatible switch, router or network interface card while the host device is powered according to the vendor instructions for hot-pluggable modules. Connect an LC duplex single-mode fiber patch cable with the correct polarity to establish Tx and Rx channels. Ensure the host device firmware or configuration allows the module to operate at 10 Gbit/s and that link partners are configured for compatible media and bit-rate settings. For DDM/DOM monitoring, enable the diagnostic interface in host hardware if supported.

Recommendations

Use single-mode LC duplex patch cables and observe proper fiber handling to avoid contamination. Verify compatibility lists for your network hardware and update device firmware if necessary to ensure full interoperability and access to diagnostic functions. For best results in long-reach links, use appropriate launch power and matched fiber grade and maintain connectors and patch panels clean and properly inspected.