Módulo Transceptor SFP BlueOptics SBC-SFPSM-1G-BO 1250 Mbit/s Fibra Ótica

The BlueOptics SBC-SFPSM-1G-BO is a single-port SFP fiber optic transceiver designed for 1000BASE-LX applications with a maximum data transfer rate of 1250 Mbit/s. Housed in a metal enclosure and weighing approximately 20 g, this SFP module supports LC duplex connectivity for single-mode fiber links and is built to comply with MSA mechanical and electrical standards. The module provides long MTBF performance and is intended for use in switches, routers and other network devices that accept SFP pluggable optics.

Advantages

The module combines a compact SFP form factor and metal housing for mechanical durability while maintaining a lightweight profile. Compliance with common MSA specifications ensures interoperability across a broad range of networking equipment. Digital diagnostics (DDM/DOM) support is available for real-time monitoring of laser power, temperature and supply parameters when supported by the host device. A long mean time between failures (MTBF) contributes to reduced maintenance cycles and predictable operational availability.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP module into an available SFP port on a compatible switch, router or transceiver slot while the host device is powered down or following the host vendor's hot-plug guidance. Connect LC duplex single-mode patch cables to the module's ports, ensuring correct transmit/receive orientation. If the host supports DDM/DOM, enable or monitor the diagnostics interface through the device management system to view supply voltage, laser bias, output and received power, and temperature. Verify link status and network configuration on the host device to confirm the optical link is active.

Recommendations

Use single-mode LC duplex cables and, where possible, patch panels or appropriate adapters to maintain optimal optical performance. Confirm host device compatibility with MSA-compliant 1000BASE-LX SFP modules and enable DDM/DOM monitoring if remote diagnostics are required. Avoid exposing the transceiver to electrostatic discharge, mechanical shock or contamination of optical interfaces; keep protective dust caps in place when the module is not connected.