Módulo transceptor SFP BlueOptics SFP-10G-BX-U-20-AN-BO 10000 Mbit/s SFP+

The BlueOptics SFP-10G-BX-U-20-AN-BO is a compact SFP+ fiber-optic transceiver module designed for 10 Gigabit Ethernet and other high-speed networking applications. Housed in a robust metal casing and compliant with RoHS and FCC standards, this module supports a maximum data transfer rate of 10000 Mbit/s while weighing just 20 g. It uses an SFP+ interface for hot-pluggable insertion into switches, routers and other compatible network devices where short- to mid-range optical links are required.

Advantages

The module combines a small form factor with a metal housing to ensure mechanical durability and effective heat dissipation. Support for the SFP+ interface enables compatibility with a wide range of 10 Gbit/s network equipment. The low weight and standardized construction make the module easy to install and replace, and compliance with RoHS and FCC helps meet regulatory and environmental requirements in professional installations.

Suitable for

Key specifications

How to use

Ensure the host device supports SFP+ transceivers and that firmware or compatibility lists include the module type. Power down or follow hot-swap procedures recommended by the equipment vendor, insert the SFP+ transceiver into the SFP+ slot until it latches, and connect the appropriate single-mode fiber patch cable to the LC connector. After insertion, verify link status on the host device and configure the port for the intended network protocol and speed if necessary.

Recommendations

Handle the fiber connectors and transceiver module with care to avoid contamination; always use dust caps when ports are not in use. Match fiber type and connector polarity to the network design, and consult device compatibility lists for confirmed interoperability. For stable long-term operation, ensure adequate ventilation around the host device to maintain appropriate operating temperature.