Módulo transceptor SFP BlueOptics SFP-10G-BX-U-IB 10000 Mbit/s SFP+

The BlueOptics SFP-10G-BX-U-IB is a fiber optic SFP transceiver module designed for high-speed network links. Supporting the SFP+ interface and a maximum data transfer rate of 10000 Mbit/s, this module enables reliable point-to-point connections over optical fiber. Its compact SFP form factor allows straightforward installation in compatible switches, routers and media converters where a short, standardized transceiver is required.

Advantages

The module provides 10 Gigabit Ethernet performance in an SFP+ package, combining high throughput with a small form factor. It supports vendor-neutral insertion into SFP+ ports and is intended for long-distance optical links, offering consistent signal integrity and stable transmission. Compatibility with standard SFP+ interfaces simplifies upgrades and replacements without major system changes.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and routers
• High-speed server connections in data centres
• Long-distance point-to-point fiber links
• Media converters and optical line terminations supporting SFP+

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s
• Form factor: SFP transceiver module
• Optical medium: single-mode/multi-mode compatibility depends on fiber and system optics

How to use

Install the BlueOptics SFP-10G-BX-U-IB by inserting the transceiver into an empty SFP+ port until it clicks into place. Connect the appropriate fiber patch cable to the transceiver’s optical port, ensuring correct TX/RX orientation for a point-to-point link. Configure the network device as required for 10 Gbit/s operation and verify link/activity LEDs or system diagnostics for a successful connection. When removing the module, release any retention mechanism and pull the transceiver straight out to avoid damage.

Recommendations

Use certified fiber patch cables and verify that the host device supports SFP+ modules with the specified optical characteristics. Handle the module carefully to keep optical interfaces clean; use dust caps when the transceiver is not connected. For critical links, test the fiber path and perform link verification after installation to confirm expected performance.