Módulo transceptor SFP+ BlueOptics SFP+LR10G-BO 10000 Mbit/s prateado

The BlueOptics SFP+LR10G-BO is a single‑mode fiber optic SFP+ transceiver module designed for 10 Gbit/s Ethernet and other high‑speed optical applications. Housed in a silver SFP+ package and weighing approximately 20 g, the module provides an LC duplex connector and supports long‑reach transmission over single‑mode fiber. The transceiver implements standard SFP+ electrical and optical interfaces for compatibility with a wide range of network switches, routers and storage equipment that accept SFP+ modules.

Advantages

This SFP+ module supports up to 10000 Mbit/s data rate and is built to MSA-compatible SFP+ mechanical and electrical specifications to ensure broad interoperability. The compact silver SFP+ form factor and lightweight construction allow easy installation and hot‑swap replacement. Designed for long‑reach single‑mode operation, the module enables reliable optical links with low susceptibility to electromagnetic interference and stable performance over extended distances.

Suitable for

Key specifications

How to use

Insert the SFP+ module into a compatible SFP+ port on a switch, router or host adapter until it seats and the latch engages; the module supports hot‑swap insertion and removal when the host supports this feature. Connect an LC duplex single‑mode fiber patch cord to the module’s LC connector—observe correct transmit/receive orientation. Configure the device interface according to the host operating system or network equipment management interface and verify link status and negotiated speed. If supported by the host, enable and read Digital Diagnostics Monitoring (DDM/DOM) data for supply voltage, temperature, transmit/receive power and laser bias information.

Recommendations

Use high‑quality single‑mode LC duplex patch cords and ensure proper fiber polarity for optimal range and performance. Verify compatibility with the target hardware and check that DDM/DOM functions are supported by the equipment if remote diagnostics are required. For reliable long‑term operation, avoid excessive bending of fiber cables and operate the module within the manufacturer’s specified temperature and voltage ranges.