Módulo transceptor SFP28 BlueOptics BO27O13610D-BO 25000 Mbit/s

The BlueOptics BO27O13610D-BO SFP28 transceiver module is a single-mode fiber optic plug-in designed for high-speed networking applications. Supporting a maximum data transfer rate of 25,000 Mbit/s, the module is housed in a durable metal enclosure and offers a compact silver SFP28 interface suitable for MSA-compliant ports. With a weight of approximately 40 g and a specified mean time between failures (MTBF) of 1,000,000 hours, this transceiver is intended for long-term deployment in switches, routers and other networking hardware that accept SFP28 form-factor modules.

Advantages

The module provides high data throughput up to 25 Gbit/s over single-mode fiber while occupying a standard SFP28 port. Its metal housing contributes to mechanical robustness and thermal stability in rack-mounted or chassis-based systems. The long MTBF figure indicates a design focused on continuous operation and reduced maintenance intervals. The compact, MSA-compatible form factor ensures interoperability with a wide range of network devices that support SFP28 transceivers.

Suitable for

• High-speed Ethernet uplinks (25G)
• Data center interconnects between switches and routers
• Server-to-switch and storage networking links
• Fiber backbone links requiring single-mode transmission

Key specifications

• Interface type: SFP28 (MSA-compliant form factor)
• Maximum data transfer rate: 25000 Mbit/s (25 Gbit/s)
• Fiber type: single-mode fiber (optical)
• Housing: metal enclosure for enhanced durability and heat dissipation
• Product colour: silver
• Weight: approx. 0.04 kg
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Install the SFP28 transceiver into an empty SFP28 port on the network device until it latches, then connect a single‑mode LC duplex fiber patch cord to the module’s optical connector. Ensure the host device is powered and configured to recognize a 25 Gbit/s SFP28 module; check that the device firmware or driver supports third‑party SFP28 transceivers if required. Monitor link status indicators on the host and verify optical power and link negotiation through the management interface. Remove the transceiver by releasing the latch and gently pulling it from the port when the device is powered down or as directed by the equipment vendor.

Recommendations

To achieve reliable performance, pair the module with single‑mode LC duplex patch cords and compatible SFP28 ports that support the desired data rate. Confirm host hardware support for SFP28 modules and, where available, enable digital diagnostics (DDM/DOM) to monitor optical parameters for proactive maintenance.