Película de vinil autolaminada Brady M7-19-427, espessura 4 mil, para proteção duradoura de etiquetas

Self-laminating vinyl wrap Brady M7-19-427, 4 mil thickness, is a clear overlaminate designed to be applied directly over printed labels and identification markers to extend their service life. The film adheres over existing printed surfaces without requiring a separate adhesive backing, creating a protective layer that resists abrasion, moisture and general wear. This product is intended for industrial labeling and asset identification tasks where protecting print legibility and durability is important.

Advantages

The self-laminating vinyl wrap offers a thin but durable 4 mil protective layer that maintains print clarity while adding resistance to scuffs and light chemical exposure. Its self-laminating application simplifies installation over pre-printed labels, eliminating the need for a separate laminate applicator or adhesive film. The clear film conforms to surfaces and helps prevent premature fading and damage from handling and environmental factors.

Suitable for

• Industrial equipment labels and nameplates
• Asset tags and inventory markers
• Wire and cable identification on panels
• Areas exposed to light abrasion, moisture or frequent handling

Key specifications

• Material: clear self-laminating vinyl
• Thickness: 4 mil (approximately 0.1 mm)
• Finish: transparent, non-yellowing film
• Protection: abrasion and moisture resistance
• Application: applied over existing printed labels without separate adhesive

How to use

Ensure the printed label surface is clean, dry and free of dust, oil or other contaminants before application. Align the self-laminating film over the printed label and press from the center outward to remove air pockets, smoothing the film until it fully adheres to the label edges. Trim any excess film as needed. Allow a short dwell time for the film to set if used in colder conditions.

Recommendations

For best results, apply the self-laminating vinyl at room temperature and on flat or gently curved surfaces. Avoid using on surfaces with heavy oils or loose paint. Regularly inspect protected labels in high-wear locations and replace the overlaminate if it becomes excessively scratched or delaminated.