Secador de filamento Creality 4005010100 para impressora 3D — compatível com SpacePi X4, preto/cinzento, 1 unid.

The Creality filament dryer 4005010100 is a filament storage and drying accessory designed to remove moisture from 3D printer filament spools. Compatible with Creality systems and specifically designed for use with the SpacePi X4, this single-unit dryer is finished in black and grey and supports drying and storage for multiple filament reels. By reducing filament moisture it helps maintain consistent extrusion, reduce nozzle clogs and improve dimensional stability during prints.

Advantages

This filament dryer offers active dehumidification with desiccant regeneration and dual independent heating chambers to handle several spools at once while maintaining precise temperature control up to 85°C. The unit incorporates an Auto Silent mode and EDry user interface for straightforward operation, and triple safety protection to reduce risks during extended drying cycles. The design supports continuous drying during storage and pre-print preparation to preserve filament quality.

Suitable for

• Drying and storing standard thermoplastic filaments (PLA, ABS, PETG, etc.) before printing
• Maintaining filament condition in humid environments
• Preparing multiple spools for long print runs or production use
• Integrating with Creality ecosystems such as SpacePi X4 for workflow convenience

Key specifications

• Capacity: up to 4 filament spools in dual independent heating chambers
• Maximum drying temperature: up to 85 °C
• Dehumidification type: active dehumidification with desiccant regeneration
• Operating modes: Auto Silent mode and EDry user interface for control
• Safety features: triple safety protection for heating and operation
• Colour: black and grey
• Unit quantity: single unit

How to use

Place filament spools inside the dryer chambers according to their diameter and secure lids before starting the unit. Select the appropriate drying temperature and time using the EDry interface or the Auto Silent mode; typical settings depend on filament type and moisture level, with lower temperatures for sensitive materials and higher temperatures for heavily absorbed filaments. Allow the drying cycle to complete and let spools cool briefly before removing to avoid handling hot surfaces. Use the desiccant regeneration option as instructed to maintain dehumidification performance over time.

Recommendations

For most filaments, start with moderate temperatures and shorter drying times and adjust based on results: PLA generally requires less drying than hygroscopic filaments such as nylon or TPU. Always follow filament manufacturer guidance for temperature limits and avoid exceeding the maximum specified temperature. Keep the dryer in a ventilated area and inspect seals and desiccant periodically to ensure consistent performance.