Serra circular manual a bateria EINHELL TE‑CS 18/165‑2 Li (Solo) — 18 V, profundidade de corte máx. 57 mm, incl. guia paralela, sem bateria/carregador

The EINHELL TE‑CS 18/165‑2 Li (Solo) is a cordless circular saw designed for the Power X‑Change battery system. Operating at 18 V, the tool delivers a maximum cutting depth of 57 mm at 90° and is supplied without battery and charger. The saw comes with a parallel guide to assist with straight, repeatable cuts and is intended for working with wood, panels and common construction materials. Its compact cordless design supports mobility on jobsites and home workshops where mains power is not convenient.

Advantages

The cordless construction removes the need for a power cord and improves maneuverability on site. Compatibility with the Power X‑Change battery system enables flexible battery use across compatible tools. The included parallel guide helps achieve accurate straight cuts while the specified maximum cutting depth of 57 mm at 90° covers typical cross and rip cutting tasks in decking, boards and panel products. Being supplied as a Solo unit allows users to combine the saw with existing EINHELL batteries and chargers.

Suitable for

• Cross and rip cutting of solid wood and timber boards
• Cutting chipboard, MDF and plywood panels
• On‑site trimming and sizing of construction timber
• Workshop tasks where cordless mobility is required

Key specifications

• Rated voltage: 18 V (Power X‑Change system)
• Maximum cutting depth at 90°: 57 mm
• Design: cordless circular saw, Solo delivery (without battery and charger)
• Accessory included: parallel guide for straight cuts
• Intended materials: wood, panels and common construction materials

How to use

Before use, install a compatible Power X‑Change battery (not included) and ensure it is adequately charged. Fit an appropriate saw blade for the material and secure it according to the manufacturer's instructions. Adjust the cutting depth and the parallel guide to the required settings, clamp the workpiece where possible, and check blade guards and safety features are functioning. Operate the saw with steady pressure, allowing the blade to reach full speed before engaging the cut, and follow standard safe‑handling practices for circular saws.

Recommendations

For accurate results, use a suitable blade for the specific material (e.g., fine‑tooth blades for plywood or MDF) and perform test cuts on scrap material to confirm depth and guide alignment. Wear appropriate personal protective equipment, maintain a secure grip, and ensure batteries are charged and compatible with the Power X‑Change system.