Cabo de rede S/CONN 75225-S 15m Cat5e SF/UTP RJ-45 preto

The ShiverPeaks Networking Cable S/CONN 75225-S is a 15 metre Cat5e cable with SF/UTP shielding and factory‑terminated RJ‑45 connectors on both ends. Designed for structured cabling and point‑to‑point network links, this cable supports data transfer rates up to 1000 Mbit/s and is intended for Ethernet installations where interference reduction and consistent signal quality are required.

Advantages

This Cat5e SF/UTP cable combines a twisted pair core with foil and braided shielding to reduce electromagnetic interference and crosstalk in electrically noisy environments. The 15 m length offers flexibility for mid‑range connections without additional patching and the standard RJ‑45 terminations ensure compatibility with switches, routers and network devices. The cable jacket and connector design provide reliable mechanical performance for repeated insertion cycles.

Suitable for

• Connecting desktop PCs, network printers and IP phones to switches or wall outlets
• Home networking between routers, modems and media players
• Small office and branch office LAN installations requiring shielded cabling
• Temporary or permanent runs where a 15 m length fits layout requirements

Key specifications

• Length: 15 metres
• Cable category: Cat5e
• Shielding: SF/UTP (foil plus braid around twisted pairs)
• Connectors: RJ‑45 on both ends
• Maximum supported data rate: up to 1000 Mbit/s
• Intended use: Ethernet networking (1000BASE‑T compatible)

How to use

Route the cable between devices so the length is adequate without excessive tension or tight bends. Insert each RJ‑45 connector firmly into the corresponding network port until the latch clicks. For best performance, avoid running the cable parallel to power lines or near large electrical equipment; use separate cable paths or conduits where practical. If terminating into wall jacks or patch panels, use the factory‑terminated RJ‑45 ends for direct connection to compatible ports.

Recommendations

Use this Cat5e SF/UTP cable in installations where reduced EMI and consistent gigabit Ethernet performance are required. For environments with very high interference or where future higher bandwidth is expected, consider shielded Cat6 or Cat6a alternatives. Store the cable coiled without sharp kinks and inspect connectors for damage before installation.