SSD M.2 2280 Silicon Power 1000GB NVMe PCIe Gen3x4, leitura 2200 MB/s, escrita 1600 MB/s

The P34A60 is an M.2 2280 NVMe SSD that provides an affordable PCIe Gen3x4 storage upgrade for novice users, DIY builders and system manufacturers. Using four PCIe lanes, it delivers read speeds up to 2,200 MB/s and write speeds up to 1,600 MB/s while remaining compact for installation in laptops, small form-factor PCs and some ultrabooks. Capacities are available up to 2TB to increase system storage without occupying additional space.

Advantages

Supporting NVMe 1.3 and HMB (Host Memory Buffer), the P34A60 offers better bandwidth scalability, increased IOPS and lower latency compared with AHCI-based drives, with the SSD using host RAM to improve internal efficiency. Built-in LDPC error correction, End‑to‑End data protection and a RAID engine improve data integrity and fault tolerance for stable operation.

Key specifications

• Interface: PCIe Gen3x4 (NVMe 1.3)
• Form factor: M.2 2280 (80 mm)
• Sequential read speed: up to 2,200 MB/s
• Sequential write speed: up to 1,600 MB/s
• Capacity: up to 2 TB
• Technologies: HMB (Host Memory Buffer), LDPC ECC, End‑to‑End data protection, RAID engine

How to use

Install the P34A60 into an M.2 2280 slot on a compatible motherboard or laptop following the device manufacturer’s instructions. Ensure the system BIOS/UEFI recognizes NVMe drives and that any necessary drivers or firmware updates are applied. After physical installation, initialize and format the drive in the operating system to make it available for use as a system or data volume.

Recommendations

For best results, back up important data before migrating or installing the SSD, enable any motherboard NVMe settings required for PCIe Gen3x4 operation, and keep firmware updated. Use the P34A60 as a primary system drive or secondary storage depending on capacity needs and available slots.