Stanley ST martelo perfurador SDS+ 800W SFMEH210K 2,4J

The Stanley ST MŁOTOWIERTARKA SDS+ 800W SFMEH210K is a rotary hammer designed for drilling and light chiseling tasks in concrete, masonry and similar materials. Equipped with an 800 W motor and an impact energy of 2.4 J, this tool provides a balance of power and control for routine professional and DIY jobs. A replaceable chuck increases versatility, allowing the use of standard SDS+ bits and accessories for a range of on-site applications.

Advantages

The rotary hammer combines a robust 800 W motor with a consistent 2.4 J impact energy to deliver steady drilling and chiseling performance. The replaceable chuck offers flexibility when changing between drill bits and chisels, and the tool’s design supports reliable operation during repeated use. Built to meet typical jobsite demands, it provides straightforward handling and efficient energy transfer for faster progress on holes and demolition tasks.

Suitable for

• Drilling holes in concrete, brick and block
• Light chiseling and removal of tiles or plaster
• Installing anchors, conduits and piping in masonry
• General renovation and construction site tasks

Key specifications

• Motor power: 800 W
• Impact energy: 2.4 J
• Tool type: SDS+ rotary hammer with replaceable chuck
• Functions: drilling and chiseling
• Suitable bit system: SDS+

How to use

Select an appropriate SDS+ drill bit or chisel and secure it in the replaceable chuck according to the manufacturer’s instructions. Set the tool to the desired mode (drilling or chiseling) and position the bit on the marked drilling point. Start the tool at low speed to establish the hole, then increase to working speed while applying steady pressure. For chiseling, use controlled strokes and allow the tool to do the work rather than forcing it. Always disconnect the tool from the power supply before changing accessories or performing maintenance.

Recommendations

Use appropriate personal protective equipment such as safety glasses, hearing protection and dust mask. For prolonged drilling in hard materials, allow occasional pauses to prevent overheating. Match bit diameter and type to the material and task to ensure efficient performance and longer bit life.