Transceptor SFP BlueOptics 10067 fibra ótica 155 Mbit/s 1310 nm

The BlueOptics 10067 Fiber optic SFP transceiver is a compact module designed for fiber-based network links. Supporting a maximum data transfer rate of 155 Mbit/s and operating at a wavelength of 1310 nm, this SFP transceiver provides a standard optical interface for connecting switches, routers or media converters to single-mode fiber networks. With a lightweight silver housing and an industry-standard SFP form factor, the module is suitable where a reliable, small-footprint fiber connection is required.

Advantages

The transceiver offers compatibility with standard SFP slots and delivers stable optical transmission at 1310 nm for distances typical of metropolitan and access networks. Its 155 Mbit/s rate fits legacy and specialized equipment that require this specific data speed. The compact construction and low weight simplify installation and reduce mechanical load on networking equipment while the single-mode fiber operation supports lower attenuation over longer runs compared with multimode alternatives.

Suitable for

• Connecting switches and routers to single-mode fiber links
• Upgrading or replacing SFP ports in access and distribution networks
• Industrial or lab equipment requiring a 1310 nm optical interface at 155 Mbit/s
• Media converters and legacy network segments with matched data rates

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 155 Mbit/s
• Optical wavelength: 1310 nm (single-mode fiber)
• Form factor: SFP module, hot-pluggable
• Weight: approximately 0.02 kg
• Colour: silver housing

How to use

Insert the SFP transceiver into a compatible SFP slot on network equipment while the device is powered off or following the vendor's hot-plug guidelines. Connect the single-mode fiber cable with appropriate LC/other compatible connector to the module's optical port, ensuring correct polarity and a clean connector end-face. After physical installation, verify link status and configure the equipment interface for the required data rate if manual settings are needed. Observe standard electrostatic discharge (ESD) precautions and protect unused ports with dust caps.

Recommendations

Use this module with single-mode fiber and matching optical transceivers at the remote end operating at 1310 nm. Confirm compatibility with the host device vendor's supported SFP modules and ensure clean fiber connectors to maintain optical performance. Store and handle the module in dry, static-free conditions when not in use.