Transceptor SFP+ BlueOptics 10G-SFPP-USR-8 10000 Mbit/s 850 nm

The BlueOptics 10G-SFPP-USR-8 is a compact SFP+ fiber optic transceiver designed for 10 Gbit/s links over multimode fiber using 850 nm wavelength. The module supports high-speed short-range connections and is suitable for use in data center switches, server uplinks and aggregation equipment where 10 Gbit/s SFP+ ports are required. The transceiver is lightweight and compact, allowing for dense port deployments and easy hot-swap replacement without interrupting other equipment.

Advantages

The module provides a stable 10 Gbit/s interface with standard SFP+ form factor, enabling straightforward installation into compatible network devices. Its 850 nm optics are optimized for short-range multimode fiber links, offering predictable performance for typical campus, rack-to-rack and data center interconnects. The small size and low weight support high-density configurations and reduce physical stress on equipment ports.

Suitable for

• Short-range multimode fiber connections (rack-to-rack, within data centers)
• 10 Gbit/s uplinks for switches and routers with SFP+ ports
• Server network adapters and storage network links requiring 10 Gbit/s
• Network upgrades where SFP+ form factor and 850 nm optics are standard

Key specifications

• Interface type: SFP+ form factor compatible with 10 Gbit/s ports
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Operating wavelength: 850 nm for multimode fiber
• Typical use: short-range multimode links (USR/short reach)
• Weight: approximately 0.02 kg
• Color: silver metal housing

How to use

Install the BlueOptics SFP+ transceiver into a compatible SFP+ slot on your switch, router or server network card with the module's latch aligned to the port. Connect multimode fiber patch cables terminated with the appropriate connectors to the transceiver’s optical interface, then verify link status through the network device management interface. The module supports hot-swap insertion and removal; ensure the remote link partner is powered and configured for 10 Gbit/s operation before data transfer.

Recommendations

Use quality OM3/OM4 multimode fiber patch cords and maintain short connector runs for reliable 10 Gbit/s performance. Verify compatibility with the host device vendor's SFP+ port documentation and update device firmware if required. Handle the transceiver by its housing, keep protective dust caps on when not in use, and avoid touching the optical interfaces to prevent contamination and signal loss.