Transceptor SFP BlueOptics 740-088322-BO 100000 Mbit/s LC

The BlueOptics 740-088322-BO is a QSFP28-class optical transceiver module designed for high-speed single-mode fiber networks. It supports a maximum data transfer rate of 100000 Mbit/s and uses an LC duplex interface in a compact metal housing finished in silver. The module is lightweight (approximately 0.04 kg) and conforms to MSA-compatible form factors for use in equipment that supports QSFP28 optical modules.

Advantages

This BlueOptics QSFP28 transceiver offers a standardized LC interface and a high maximum data throughput of 100 Gbit/s, enabling integration into modern data center and carrier environments. The metal casing provides mechanical robustness and thermal stability while the small, industry-standard form factor facilitates hot-plug installation and dense port packing. The transceiver is manufactured to meet optical module interoperability standards and is suitable for applications that require single-mode fiber connections.

Suitable for

• High-bandwidth Ethernet links up to 100 Gbit/s
• Interconnects between switches, routers and storage systems using single-mode fiber
• Data center uplinks and aggregation layers
• Carrier and metro network links where LC interfaces are used

Key specifications

• Interface type: LC duplex
• Maximum data transfer rate: 100000 Mbit/s (100 Gbit/s)
• Fiber type: single-mode fiber (SMF)
• Housing material and colour: metal casing, silver
• Weight: 0.04 kg

How to use

Install the transceiver into a compatible QSFP28 port on a switch, router or other networking device following the device manufacturer’s instructions for hot-plug modules. Connect LC duplex single-mode fiber patch cords to the transceiver’s LC ports, ensuring correct Tx/Rx orientation. After insertion and cabling, verify link status and negotiated speed on the host device. If the host requires specific module settings or validation, follow the host vendor’s guidance to enable full functionality.

Recommendations

Use high-quality single-mode fiber patch cords and maintain clean connector endfaces to ensure optimal signal quality. Confirm that the target hardware supports QSFP28 optical modules at 100 Gbit/s and that any required digital diagnostics or firmware settings are enabled on the host system.