Transceptor SFP de fibra ótica BlueOptics UACC-OM-MM-1G-D-BO 550 m

The BlueOptics UACC-OM-MM-1G-D-BO is a 1000Base-SX compatible SFP fiber optic transceiver designed for multi-mode fiber links up to 550 meters. Housed in lightweight aluminium and weighing approximately 20 grams, this SFP module provides a compact interface for 1 Gbit/s optical connections using an LC duplex connector and operates at 850 nm for both transmitter and receiver. The transceiver follows MSA (multi-source agreement) form-factor standards and is suitable for integration into network switches, routers, storage systems and other hardware platforms that accept standard SFP modules.

Advantages

The module offers gigabit optical data transfer over multi-mode fiber with a maximum reach of 550 m and supports simultaneous transmit and receive channels via LC duplex. Its aluminium housing is durable while remaining lightweight, facilitating easy handling and installation. The transceiver is manufactured to MSA standards and is tested for compatibility with devices that support the corresponding 1000Base-SX SFP, and it includes digital diagnostics (DDM/DOM) support when the host hardware exposes that function.

Suitable for

Key specifications

How to use

Before insertion, ensure the SFP slot on your device supports 1000Base-SX SFP modules and that the host firmware does not restrict third-party transceivers. Remove protective caps from the LC connector and the module port. Insert the transceiver into the SFP slot until it latches; connect an LC duplex multi-mode fiber patch cord to establish the optical link. Configure the network interface in your device management console or operating system as required. If digital diagnostics are available and supported by your equipment, monitor supply voltage, laser bias current, optical output/input power and module temperature via the host system for maintenance and troubleshooting.

Recommendations

For optimal link performance, use matched multi-mode fiber (OM1/OM2/OM3/OM4 as appropriate) and quality LC duplex patch cords, maintain clean connector endfaces, and verify compatibility with the target device. Observe ESD precautions when handling the module and store unused modules with protective caps fitted.