AOC CBO Marconi SFP-AOC-10G-50M Cabo ótico ativo 10G, 50 m

The AOC Marconi SFP-AOC-10G-50M is a 10 Gigabit Active Optical Cable designed for direct-attach use with SFP+ ports. At 50 meters length, this BlueOptics-branded cable provides a fiber-based link that reduces electrical interference and attenuation compared with equivalent copper assemblies. The integrated SFP+ connectors and factory-terminated optical fibers deliver consistent high-speed, low-latency transmission suitable for data center topologies, switch-to-switch links and storage network connections.

Advantages

The active optical design offers higher signal integrity over longer distances than copper, with lower heat dissipation and reduced electromagnetic interference. Factory-terminated connectors simplify installation and eliminate field splicing, while the SFP+ form factor ensures compatibility with standard SFP+ ports for plug-and-play deployment. The cable’s 50 m reach enables flexible rack placement and longer server-to-switch or switch-to-switch connections within a single facility.

Suitable for

• Data center server-to-switch links requiring 10 Gbps throughput
• Switch-to-switch uplinks where 50 m optical reach is needed
• Storage area networks (SANs) and networked storage interconnects
• High-density rack environments that prioritize cable management and EMI resilience

Key specifications

• Nominal data rate: 10 Gigabit per second (10 Gbps)
• Connector type: SFP+ integrated optical transceivers (factory-terminated)
• Physical medium: multimode optical fiber within active optical cable assembly
• Maximum link length: 50 meters
• Typical latency: low, suitable for latency-sensitive applications
• Compatibility: designed for devices with SFP+ ports supporting 10G links

How to use

Install the cable by inserting each integrated SFP+ end into the corresponding SFP+ ports on the connected devices until the latch engages. Ensure devices are powered down or follow hot-swap procedures recommended by the equipment vendor if inserting while powered. Verify link status on both endpoints and configure network settings as needed for 10 Gbps operation. Route the cable to avoid tight bends and protect the optical assembly from mechanical stress.

Recommendations

Handle the cable by the connector housings and avoid kinking or sharp bends that could compromise the fiber. Maintain clean connector endfaces and follow standard fiber-cleaning procedures before insertion. Use this AOC where a predictable 50 m optical reach and SFP+ compatibility are required; for longer distances or different port types, consider optical transceivers with separate fiber patch cords or alternative cabling solutions.