Cabo ótico ativo CBO AOC QSFP-100G-AOC-20M, QSFP para QSFP, 100 Gbit/s, 20 m

The CBO AOC QSFP-100G-AOC-20M active optical cable is a QSFP-to-QSFP 100 Gbps interconnect with a 20 meter reach designed for high-density data center and enterprise network environments. This BlueOptics cable integrates optical transceivers into the cable assembly to provide a plug-and-play connection between compatible QSFP 100G ports, eliminating the need for separate transceiver modules. The cable supports high-bandwidth, low-latency links between switches, routers and servers while maintaining a compact form factor and reduced power consumption compared with separate SFP/QSFP modules and electrical cabling.

Advantages

The active optical design delivers reliable 100 Gbps throughput over a 20 m distance with consistent signal quality and reduced electromagnetic interference. Integration of the optical interfaces in the assembly simplifies installation and inventory management by removing the requirement for standalone transceivers. The cable’s flexible jacket and low weight make it easier to route in dense rack environments, and lower heat dissipation contributes to improved cooling efficiency in equipment cabinets.

Suitable for

• Interconnects between 100G-capable switches in data center top-of-rack and spine deployments
• High-speed links between routers and aggregation devices in carrier and enterprise networks
• Server-to-switch connections where QSFP 100G ports are available
• Short to medium reach optical links inside racks and between adjacent racks up to 20 meters

Key specifications

• Connector type: QSFP to QSFP optical assemblies
• Data rate: 100 Gbps aggregate bandwidth
• Length: 20 meters
• Type: Active optical cable (AOC) with integrated optical transceivers
• Application: Multi-lane 100G links for switches, routers and servers
• Physical: Lightweight, flexible jacket designed for rack cabling

How to use

Install the cable by inserting each QSFP connector into the corresponding 100G QSFP port on networking equipment until the connector latches. Ensure both ends are securely seated and that the connected devices are powered and configured to use a 100G link. No additional transceiver modules or fiber patch cords are required. Verify link status and speed through the device management interface and monitor for any alerts related to link integrity or optical parameters.

Recommendations

Route the cable carefully to avoid tight bends and mechanical stress; maintain manufacturer minimum bend radius. Use cable management accessories in racks to prevent strain on connectors and to keep airflow unobstructed. Confirm compatibility with the networking equipment’s QSFP 100G ports and firmware; if necessary, update device firmware to ensure proper recognition and optimal performance.