Módulo transceptor SFP+ CBO 7SP-402-BO 10 Gbit/s

The SFP+ Transceiver Module CBO 7SP-402-BO 10 Gbit/s is a hot-pluggable optical transceiver designed to add 10 Gbit/s connectivity to compatible network equipment. It fits standard SFP+ ports and supports short- to medium-range fiber links depending on the fiber type and operating wavelength. The compact form factor makes it suitable for use in switches, routers and server network interface cards when expanding uplink capacity or creating high-speed point-to-point connections.

Advantages

The module delivers 10 Gbit/s line rate with low power consumption and a standardized SFP+ footprint for easy installation and replacement. Its hot-pluggable design allows insertion and removal without powering down the host device. The transceiver is compatible with common single-mode or multimode fiber configurations (dependent on the selected optics) and offers reliable optical performance for data centre and enterprise networks. Built to industry interoperability guidelines, it supports straightforward integration with many third-party network platforms.

Suitable for

• Adding 10 Gbit/s uplinks to network switches and routers
• Creating short- to medium-range fiber connections between switches and servers
• Upgrading server NICs to higher-speed links
• Replacing failed or legacy SFP+ optical modules

Key specifications

• Data rate: 10 Gbit/s
• Form factor: SFP+ (hot-pluggable)
• Optical link range: short to medium range depending on fiber type and wavelength
• Compatible media: single-mode or multimode fiber (optics dependent)
• Typical use: uplinks, point-to-point links, server connections
• Power consumption: low (typical for SFP+ transceivers)

How to use

Insert the transceiver into an available SFP+ port on the powered host device until it clicks into place. Connect the appropriate fiber patch cable, ensuring correct fiber type and connector compatibility. Verify link status via the host device indicators or management interface. To remove, release the module latch and pull the transceiver straight out; protect optical interfaces with dust caps when not in use. Follow your equipment vendor’s guidelines for compatibility and supported operating modes.

Recommendations

Choose fiber type and cable length according to the intended link distance and bandwidth needs. Verify compatibility with the host device and check link diagnostics after installation to confirm proper operation. Handle the optical connector ends carefully and store unused modules with protective caps to prevent contamination.