Transceptor CBO SFP-10G-ZR fibra ótica 10G 80km

The Transceiver CBO SFP-10G-ZR Fiber Optic 10G 80km is a single‑module SFP optical transceiver designed for long‑distance 10 Gigabit Ethernet links. It supports a 10 Gbps data rate and optical reach up to 80 km over single‑mode fiber, enabling connection of remote network segments without intermediate repeaters. The module fits standard SFP+ slots and is suitable for deployment in telecom, metro and data center environments where extended reach and interoperability with SFP+ ports are required.

Advantages

This transceiver offers a reliable long‑reach solution with a compact SFP form factor that simplifies installation and replacement. It supports 10G speeds while maintaining low power consumption typical of SFP modules. The unit is compatible with standard single‑mode fiber infrastructure and provides stable optical performance for backbone and inter‑site links. Built for interoperability, it allows integration with a wide range of network equipment that accept SFP+ optical modules.

Suitable for

• Long‑distance 10 Gigabit Ethernet links between data centers and POPs
• Metro and backbone network connections requiring up to 80 km reach
• Enterprise campus links and carrier aggregation where single‑mode fiber is deployed

Key specifications

• Data rate: 10 Gbps
• Optical reach: up to 80 km over single‑mode fiber
• Form factor: SFP/SFP+ compliant
• Wavelength: typically for long‑reach optical windows (single‑mode)
• Connector type: LC duplex
• Power consumption: low, typical for SFP modules

How to use

Install the transceiver into an available SFP+ slot on compatible networking equipment until it clicks into place, then connect LC duplex single‑mode fiber cables to the module. Ensure that the transmitting and receiving ends use matching wavelengths and that fiber polarity is correct. After physical installation, verify link status and configure network interfaces at the switch or router as required for 10 Gbps operation.

Recommendations

For reliable long‑reach performance, use certified single‑mode fiber and clean connectors before mating. Verify device compatibility with vendor documentation and monitor link parameters such as signal level and error counters to ensure stable operation over the full 80 km span.