Transceptor SFP+ CBO SFP-10G-BX-D 10G fibra ótica para ligações BiDi de fibra única

The BlueOptics SFP+ Transceiver CBO SFP-10G-BX-D is a 10 Gigabit fiber optic module engineered for single‑fiber bidirectional (BiDi) links. Designed to fit standard SFP+ ports, this transceiver transmits and receives 10G Ethernet over a single optical fiber by using different wavelengths in each direction. The module reduces fiber cabling requirements and is suitable for environments where duplex fiber is limited, such as data center uplinks, metro aggregation and enterprise fiber runs.

Advantages

This SFP+ transceiver supports full 10G data rates in a compact SFP+ form factor, enabling straightforward integration into existing SFP+ ports. By using single‑fiber BiDi technology, it halves the fiber count compared with duplex modules while maintaining standard 10G transmission. The module is compatible with common network switches and routers that accept SFP+ optics and is intended for stable, low-latency connectivity in short to medium reach fiber networks.

Suitable for

• Data center uplinks and server aggregation where fiber infrastructure is constrained
• Metro and campus fiber links requiring efficient fiber usage
• Enterprise backbone segments connecting switches and routers at 10G speeds
• Upgrading existing single‑mode fiber runs to 10G without adding additional fibers

Key specifications

• Form factor: SFP+ (10 Gigabit)
• Transmission mode: Single‑fiber bidirectional (BiDi)
• Nominal data rate: 10 Gbps
• Fiber type: Single‑mode fiber
• Connector: LC duplex interface implemented for single‑fiber BiDi operation (wavelength‑separated Tx/Rx)
• Operating distance: designed for short to medium reach single‑mode links (refer to vendor distance classes for exact reach)
• Wavelength: uses different wavelengths for transmit and receive channels

How to use

Install the transceiver into any compatible SFP+ slot following the host device’s insertion procedure and ensure proper seating until it latches. Use a single‑mode fiber patch cord with LC connectors and verify correct orientation of the Tx/Rx pair according to the host device documentation. After insertion, confirm the link status and speed via the switch or router management interface and monitor optical link diagnostics if supported. When removing the module, power down or follow hot‑swap guidelines provided by the equipment manufacturer and use dust caps to protect the optical interfaces when not connected.

Ieteicamais lietošanas veids / Usage recommendations

Install and operate the module in equipment that supports SFP+ optics and BiDi wavelengths; ensure fiber cleanliness and proper connector care to avoid signal degradation. Match the module’s wavelength direction with the counterpart transceiver at the other link end. Use appropriate transceiver settings in the host device and consult hardware compatibility lists where necessary.