BlueOptics UACC-AOC-SFP10-20M-BO cabo de fibra ótica InfiniBand SFP+ 20 m macho/macho

The BlueOptics UACC-AOC-SFP10-20M-BO InfiniBand fibre optic cable SFP+ 20m Male/Male is a 20-metre active optical cable (AOC) with SFP+ connectors designed for high-speed links in data centres and high-performance computing environments. Manufactured to MSA-compliant SFP+ form factors, the cable integrates transmitter and receiver modules on each end and supports multimode fibre transmission for 10 Gbps-class applications over a fixed 20 metre length. The pre-terminated AOC delivers a single, ready-to-install fibre connection without the need for field termination or patching.

Advantages

The BlueOptics AOC provides electromagnetic immunity inherent to fibre-optic links and eliminates the requirement for separate transceivers and patch cords. Its factory-assembled SFP+ to SFP+ configuration reduces insertion steps and potential attenuation from connectors. Components are selected and tested to meet MSA interface requirements and to ensure interoperability with hardware platforms that support SFP+ AOCs. The integrated design simplifies installation and lowers maintenance compared with separate fibre patching solutions.

Suitable for

Key specifications

How to use

Insert each SFP+ connector into the corresponding SFP+ slot on the devices you wish to interconnect, ensuring that the link partners support SFP+ AOCs. The cable is pre-assembled and requires no additional patching or fibre polishing. After seating the modules, verify link status and speed through the host devices. If the hardware supports digital diagnostic monitoring (DDM/DOM), enable or check the diagnostics through the device management interface to observe parameters such as optical power and temperature when available.

Recommendations

Install the cable in protected routing paths to avoid excessive bending; observe manufacturer minimum bend radius. Confirm that the target devices accept SFP+ AOC modules and that firmware or software settings do not block third-party modules. For best results, handle SFP+ connectors by their housing and avoid touching optical interfaces; keep unused ports covered.