Cabo de fibra ótica InfiniBand BlueOptics 5 m SFP+ preto 740-037250-BL

The BlueOptics InfiniBand/fibre optic cable 5 m SFP+ Black 740-037250-BL is a 5-metre SFP+ cable designed for short-range, high-speed connections in racks and between adjacent racks. It provides a direct attach solution with male-to-male SFP+ connectors and supports data rates up to 10 Gbit/s on a 5 m span. The cable is intended for use in systems that accept SFP+ direct attach cabling and is suitable for Ethernet, FCoE and InfiniBand protocols when used within the specified distance and supported hardware platforms.

Advantages

This SFP+ 5 m cable offers low-latency, low-power passive connection for high-density rack environments. It follows MSA-compliant connector standards and is built from quality components to ensure reliable signal transmission and long service life. The passive twinax design requires no external power or active electronics in the cable, reducing failure points and simplifying installation and maintenance.

Suitable for

• Connecting switches and routers inside a rack or between adjacent racks
• High-speed server-to-switch links in data centres
• Storage systems and SAN interconnects using 10G protocols
• Short-distance InfiniBand and FCoE connections up to 5 m

Key specifications

• Connector type: SFP+ male to SFP+ male
• Length: 5 metres
• Maximum supported data rate: up to 10 Gbit/s
• Cable type: passive twinax copper direct attach
• Power consumption: passive design with minimal cable power draw
• Form factor: suitable for rack use and short inter-rack links

How to use

Insert each SFP+ connector firmly into the corresponding SFP+ port on the devices to be linked, ensuring both devices support passive direct attach SFP+ cabling. Route the cable through the rack openings or cable management to avoid sharp bends; maintain the specified 5 m maximum span for rated performance. No additional configuration is required for the cable itself, but verify the host devices accept passive DAC SFP+ modules and that firmware or vendor settings permit third‑party cables if applicable.

Recommendations

Use this 5 m SFP+ cable for short, high-bandwidth connections inside racks and between adjacent racks where a passive, low-latency link is required. Avoid tight bends and exposure to mechanical stress, and confirm device compatibility before deployment.