Cabo de fibra ótica METZ CONNECT 151P7JAJAC0E LC I-V(ZN) H 30 m branco

The METZ CONNECT 151P7JAJAC0E LC I-V(ZN) H is a 30 m fibre optic cable designed for high-performance network connections. Featuring LC connectors on both ends and a white I-V(ZN) H jacket, the cable uses G.657.A2 single-mode fibre with a 9 µm core diameter to deliver low-loss, high-speed optical transmission for indoor and sheltered installations. The cable length and connector type make it suitable for structured cabling, patching between panels and active equipment, and extending backbone runs where single-mode performance is required.

Advantages

The cable combines G.657.A2 fibre characteristics with LC-to-LC connectivity to provide low attenuation, good bend tolerance and consistent single-mode performance over 30 m. Its I-V(ZN) H jacket and white colour allow for discreet routing and easy identification within cabling infrastructure. LC connectors offer compact, reliable mating compatible with modern transceivers and patch panels.

Suitable for

• Indoor single-mode patching between switches, transceivers and fibre panels
• Structured cabling in offices, data closets and telecom rooms
• Short backbone or horizontal links requiring low-loss single-mode fibre
• Environments where compact LC connectors and good bend performance are needed

Key specifications

• Fibre type: G.657.A2 single-mode
• Core diameter: 9 µm
• Cable length: 30 m
• Cable construction: I-V(ZN) H jacket
• Connectors: LC to LC
• Colour: White

How to use

Prepare equipment by verifying LC-compatible ports on switches, transceivers or patch panels. Remove protective caps from LC connectors and ensure connector endfaces are clean before mating. Route the 30 m cable with gentle bends to avoid tight radii; follow fibre bend-radius guidelines for G.657.A2 to maintain signal integrity. Plug LC connectors into corresponding ports until they click, and secure cable runs using appropriate cable management to prevent stress on connectors.

Recommendations

Use a fibre inspection pen and cleaning tools to check and clean connector endfaces before installation. Avoid sharp bends and mechanical strain; maintain recommended bend radius for single-mode fibre. Store connectors with protective caps when not in use and label cable ends for easier identification in dense installations.