Cabo de rede EFB Elektronik K8104GE.7,5 RJ-45 Cat6 7,5 m amarelo

The EFB Elektronik K8104GE.7,5 is a Cat6 networking cable measuring 7.5 meters with RJ-45 connectors on both ends. Designed for wired Ethernet connections, this U/UTP cable supports data transfer rates up to 5000 Mbit/s and features gold-plated contacts to improve signal transmission and limit corrosion. The yellow jacket provides clear visual identification for cabling runs in home, office, or data center environments.

Advantages

The cable conforms to the Cat6 specification, providing support for higher bandwidth and more stable connections compared with lower-category cables. The U/UTP construction reduces interference without an overall shield, making it suitable for typical office and home installations. Gold-plated contacts enhance connector reliability and contact resistance over time. Its 7.5 m length offers flexibility in device placement while the bright yellow sheath simplifies cable management and traceability.

Suitable for

• Wired Ethernet connections for computers, switches and routers
• Home and small office networks requiring Cat6 performance
• Temporary or permanent cabling where color-coded identification is useful
• Connecting networked devices at medium distances (up to 7.5 m)

Key specifications

• Standard: Category 6 (Cat6)
• Length: 7.5 m
• Connector type: RJ-45 to RJ-45
• Cabling: U/UTP (unshielded twisted pair)
• Maximum data rate: up to 5000 Mbit/s
• Contact plating: gold-plated contacts
• Colour: yellow

How to use

Connect one RJ-45 end to the network port of your device (PC, switch, router) and the other RJ-45 end to the corresponding network port. Ensure connectors are fully inserted until the latch clicks to establish a reliable physical connection. For best performance, avoid sharp bends and kinks in the cable and keep the run away from strong electromagnetic interference sources such as unshielded power lines or heavy machinery.

Recommendations

Use this Cat6 cable for desktop setups, patching between wall outlets and switches, or for lab and temporary installations where clear visual identification is important. Replace the cable if connector damage or severe sheath wear is observed. For deployments requiring additional protection against electromagnetic interference, consider using shielded cabling or routing away from known interference sources.