Cabo divisor de alimentação ACT AK3194 3x 5,25 polegadas 0,20 m

The ACT Powersplitter cable ACT AK3194 3x 5,25" 0.20 m provides a compact solution for powering multiple 5.25" devices from a single Molex (4-pin) power source. With a 0.20 m cable length and robust Molex connectors, this splitter enables convenient distribution of power inside desktop PC cases where additional peripheral drives or devices need a reliable feed from an existing power supply line.

Advantages

The cable offers a short, tidy connection that reduces cable clutter and improves airflow inside the chassis. High-quality Molex (4-pin) connectors on both the input and outputs ensure a secure electrical contact and straightforward installation. Its three-output design makes it possible to expand device count without adding extra power supply cables, while the compact 0.20 m length is suitable for close-proximity device mounting.

Suitable for

• Powering up to three 5.25" drives or peripherals from one Molex connector
• PC builds with limited internal space where short cable runs are preferred
• Adding legacy optical drives, fan controllers or other Molex-powered accessories

Key specifications

• Cable length: 0.2 m
• Connector 1: Molex (4-pin)
• Connector 2: 3 × Molex (4-pin)
• Application: internal PC power splitting for 5.25" devices

How to use

Connect the Molex (4-pin) input connector to an available Molex socket from the PC power supply. Route the 0.20 m cable carefully to the target 5.25" devices and plug each Molex output into the corresponding device power inlet. Ensure connectors are fully seated and avoid forcing connectors at unusual angles. Power on the system and verify that each connected device receives power and operates normally.

Recommendations

Use the splitter only for standard 5.25" peripherals designed for Molex (4-pin) power. Avoid overloading the single supply line by checking the combined current draw of connected devices against the power supply's specifications. Keep the cable away from moving parts and route it to maintain good airflow and prevent strain on connector pins.