Cabo ótico ativo AOC SFP28 BlueOptics BO272703Q1M 1M, 1 m, SFP28

The CBO AOC SFP28 BlueOptics BO272703Q1M 1M active optical cable is a factory-terminated fiber assembly with SFP28 connectors designed for 25 Gb/s short-reach links. It integrates electrical-to-optical conversion inside the cable ends to provide a compact, low-latency connection between servers, switches and storage devices. The 1 m length suits top-of-rack and adjacent-rack connections where space and signal integrity are priorities. The AOC construction reduces electromagnetic interference and eliminates the need for separate transceiver modules and patch cables, simplifying cabling in modern data centre and enterprise network deployments.

Advantages

The cable delivers reliable 25 Gb/s throughput with low power consumption and minimal signal loss over the short 1 m span. Factory-polished optical interfaces and pre-terminated SFP28 connectors ensure consistent performance and quick installation without connector termination in the field. The integrated optical conversion and shielded housing reduce EMI, improve link stability and lower overall cabling complexity in dense rack environments. Its compact, single-assembly design helps improve airflow and reduces points of failure compared with multi-component links.

Suitable for

• Short-reach 25 Gb/s connections between servers and top-of-rack switches
• High-density switch-to-switch links inside data centre racks
• Direct links to storage arrays and network appliances requiring SFP28 ports
• Environments where reduced EMI and simplified cabling are required

Key specifications

• Connector type: SFP28 at both ends
• Length: 1 meter
• Data rate: 25 Gb/s
• Cable type: active optical cable (AOC) with integrated optical transceivers
• Target application: short-reach intra-rack and adjacent-rack links
• Typical benefits: reduced EMI, low latency, factory-terminated optical interfaces

How to use

Install the cable by inserting each SFP28 connector into the corresponding SFP28 port until the module latches. Ensure devices are powered down or port hot-swap is supported by the equipment before insertion if required by the host. Verify link status and speed on both connected devices through management interfaces or led indicators. No field termination is needed; the cable is ready to use out of the package. For removal, unlatch the connector and pull straight out to avoid stressing the cable assembly.

Recommendations

Use the 1 m AOC for connections within the same rack or to adjacent racks to maintain optimal signal integrity. Avoid tight bends and excessive pulling force; respect the manufacturer's minimum bend radius. Keep optical interfaces clean and protect the connectors with dust caps when not connected to prevent contamination and ensure long-term performance.