Cabo patch Digitus CAT 6 S/FTP DK-1644-030-G-10

Patch cord Digitus CAT 6 S/FTP DK-1644-030-G-10 is a 3 m Category 6 (Class E) network patch cable with S/FTP shielding and RJ-45 connectors on both ends. The cable is designed and tested to ISO/IEC 11801 and DIN EN 50173 Category 6 specifications, offers performance up to 250 MHz and supports PoE+ applications. The sheath is LSZH (Low Smoke Zero Halogen) and the molded boots include kink protection, strain relief and latch protection. The product comes as a set of 10 units.

Advantages

The S/FTP shielding provides improved protection against electromagnetic interference, ensuring stable high-speed data transmission up to 250 MHz. The LSZH sheath reduces toxic fumes and smoke in case of fire, while copper conductors ensure reliable signal quality. Molded boots with kink protection, strain relief and latch protection prolong connector life and simplify handling. The transparent green connector color allows easy visual identification in patch panels and cable runs.

Suitable for

• Structured cabling in offices and data centers
• Connection of switches, patch panels and network devices
• Power over Ethernet installations (PoE/PoE+)
• Applications requiring low-smoke, low-toxicity cabling

Key specifications

• Standard: Category 6 (Class E), ISO/IEC 11801, DIN EN 50173
• Frequency range: up to 250 MHz
• Shielding: S/FTP (overall foil + individually shielded pairs)
• Conductor: Copper (Cu)
• Length: 3 m
• Connectors: RJ-45 – RJ-45, molded boots with kink and latch protection
• Sheath: LSZH (Low Smoke Zero Halogen)
• PoE: PoE+ ready
• Package: 10 units
• Color: Green (transparent connector)

How to use

Plug one RJ-45 connector into the network port of your switch, patch panel or device and the other into the corresponding port on the target device. Ensure connectors are fully inserted until the latch engages. Route the cable without sharp bends; use the molded boot with kink protection to reduce stress at the connector. For installations in racks or trunking, arrange cables to avoid compression and excessive heat.

Recommendations

For best performance, use the patch cords within the same category cabling channel, maintain appropriate bend radius (no less than 4× cable diameter), and avoid running parallel to high-voltage power lines. Replace any cable with visible damage to the sheath or connector. Store unused cords coiled loosely to prevent deformation.