Conjunto de faders motorizados Behringer MF100T – 5 faders motorizados de substituição para a série X-TOUCH

Set of five Behringer MF100T motorized replacement faders designed for use with compatible X-TOUCH series controllers. Each fader provides motor-driven position feedback to restore automated mix control and enable tactile channel adjustments. The components are intended for repair, refurbishment or customization of X-TOUCH units where original motorized fader functionality is required.

Advantages

These motorized faders offer precise, motor-controlled movement that mirrors digital automation, reducing manual recalibration and improving repeatable mix settings. Installation of the set returns responsive tactile control to channels while supporting hands-on workflow and faster session setup. The design targets straightforward replacement of worn or damaged faders on supported control surfaces.

Suitable for

• Repairing or refurbishing Behringer X-TOUCH series controllers
• Replacing worn or faulty motorized faders
• Customizing control surfaces to restore automated fader automation
• Studio maintenance where reliable motor feedback is required

Key specifications

• Quantity: set of five motorized faders
• Motorized operation with position feedback for automated control
• Form factor intended to fit X-TOUCH series fader slots
• Mechanical travel and slider ergonomics matched to standard console faders
• Electrical interface compatible with original X-TOUCH fader connections

How to use

Power down and disconnect the X-TOUCH controller before beginning any repair. Remove the control surface cover or fader channel assembly to access the existing faders, then desolder or disconnect the original units according to the controller service instructions. Install each MF100T unit into the corresponding fader slot and reconnect wiring or connectors, ensuring correct orientation and secure electrical contacts. Reassemble the control surface, power on the controller and perform a calibration or motor centering routine if required by the device firmware to synchronize physical fader positions with the controller's digital state.

Recommendations

Use ESD precautions when handling the faders and follow the manufacturer's service procedures. If uncertain about disassembly or soldering, seek professional servicing to avoid damage to the controller. After installation, verify motor response across the full travel and run any available calibration routines to ensure accurate position feedback during automated sessions.