Módulo SFP BlueOptics compatível com F5 Networks F5-UPG-SFPLX-R, transceptor de fibra ótica de porta única

BlueOptics compatible SFP module designed as a direct replacement for the F5 Networks F5-UPG-SFPLX-R. This single-port fiber transceiver fits standard SFP slots and provides optical connectivity for network equipment that accepts compatible SFP modules. It is intended for restoring or extending fiber links in switches, routers and other SFP-capable devices while maintaining interoperability with supported hardware.

Advantages

The module offers plug-and-play installation into SFP interfaces without requiring configuration changes on the host device. As a compatible replacement for the specified F5 Networks transceiver, it enables quick swap-out of faulty modules or cost-effective network upgrades. The single-port fiber design provides a compact form factor suitable for high-density network setups and minimizes downtime during maintenance.

Suitable for

• Replacing defective SFP transceivers in switches and routers that accept compatible modules
• Expanding optical links for enterprise and data center cabling
• Deployments where a single-port SFP fiber transceiver is required

Key specifications

• Form factor: SFP (small form-factor pluggable) single-port fiber transceiver
• Connectivity: optical fiber interface for single-port operation
• Compatibility: designed to be compatible with devices accepting the F5 Networks F5-UPG-SFPLX-R transceiver
• Usage environment: intended for use in switches, routers and other SFP-capable network equipment

How to use

Power down the host device if recommended by the equipment vendor, remove the faulty SFP module and insert the BlueOptics compatible SFP into a free SFP slot until it locks in place. Connect the appropriate fiber patch cable to the module's optical port and restore power or enable the port per the host device's procedures. Verify link status and configure any required interface settings on the network device according to its documentation.

Recommendations

Use factory-quality single-mode or multimode fiber and compatible LC/SC patch cords as specified by your network equipment. Ensure firmware and interface settings on the host device support third-party compatible SFP modules and follow electrostatic discharge (ESD) precautions during handling and installation.